[CA] E120W Hybrid problem with Sonar
|
05-04-18, 03:32 PM
(This post was last modified: 05-07-18 10:23 AM by Chuck - Raymarine - Moderator.)
Post: #2
|
|||
|
|||
RE: [CA] E120W Hybrid problem with Sonar
Welcome to the Raymarine Forum Bert,
If the transducer is an in-hull transducer, then the transducer's reservoir should be inspected to ensure that it is full. Should the symptom shown on the display occur when the vessel is in the water and the depth of the water is at least 3' beneath the transducer, but not exceeding the maximum depth supported by the transducer and sounder module, then the symptom would typically be indicative of a problem with the sounder module necessitating that it be sent to Raymarine’s Product Repair Center to be bench checked / serviced. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[CA] E120W Hybrid problem with Sonar - BertA - 05-04-18, 02:12 PM
RE: [CA] E120W Hybrid problem with Sonar - Chuck - Raymarine - Moderator - 05-04-18 03:32 PM
RE: [CA] E120W Hybrid problem with Sonar - BertA - 05-05-18, 10:22 AM
RE: [CA] E120W Hybrid problem with Sonar - Chuck - Raymarine - Moderator - 05-07-18, 09:20 AM
RE: [CA] E120W Hybrid problem with Sonar - BertA - 05-07-18, 09:58 AM
RE: [CA] E120W Hybrid problem with Sonar - Chuck - Raymarine - Moderator - 05-07-18, 10:37 AM
|
User(s) browsing this thread: 1 Guest(s)