The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] Mercmonitor to Axiom interface

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Mercmonitor to Axiom interface
05-12-18, 07:46 PM (This post was last modified: 05-15-18 10:18 AM by Chuck - Raymarine - Moderator.)
Post: #1
ranmar850 Offline
Junior Member
**
 		Posts: 12
Joined: Feb 2018
Reputation: 0
[CA] Mercmonitor to Axiom interface
I have recently installed a new Mercury 150 4 stroke with Mercmonitor gauge and gateway on my new Axiom RVX/Axiom RV network. All network functionality is there, integration of EV-100 was successful, electronics all work great. I have connected the NMEA network to the gateway via the appropriate connection point. Mercmonitor is set to NMEA2000 as Gateway, and set to Transmit. As Merc don't give any Raymarine specific instructions anywhere I can find, I went via the instructions for integration to Lowrance/Simrad, which are pretty basic, as I have done above. But when I go to Identify Engine on the MFD, it cannot find it. I am currently 3.4xx.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA] Mercmonitor to Axiom interface - ranmar850 - 05-12-18 07:46 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication