The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Thread Closed 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Dock to Dock autorouting with MFDs running LightHouse II software
05-14-18, 09:15 AM (This post was last modified: 05-14-18 09:16 AM by Chuck - Raymarine - Moderator.)
Post: #1
Dock to Dock autorouting with MFDs running LightHouse II software
Dock to Dock autorouting with MFDs running LightHouse II software

Detailed instructions for the Dock to Dock Autorouting feature may be found within Chapter 13.2 - Routes of the LightHouse II Release 19 Operating Instructions. When using LightHouse II v19.03 software, one may autoroute from the vessel's position or between two points specified by the user.

To autoroute between two points specified by the user,
1. a Navionics chart card is present within the Axiom MFD's memory card reader, a networked Axiom MFD's memory card reader, or within the accessory USB memory card reader.
2. ensure that your Navionics chart card has an active Navionics Freshest Data subscription and has been updated with Freshest Data updates to the chart card's Nautical Charts within the last 365 days.
3. the vessel's minimum safe depth, minimum safe height, and minimum safe width data have been entered into the MFD's Boat Details
4. open a Chart application page or page featuring the chart application
5. pan the chart to the location which you would like to be the route's departure point
6. touch and hold your finger pressed to the Chart application's screen to display the Chart pop-up menu
7. select "Build route" from the Chart pop-up menu
8. touch the displayed chart at the location of the desired first waypoint
9. touch and the displayed chart at the location of the desired destination (maximum distance 100nm or 250 turn points)
10. select "Finish Build" from the Build Route menu.
11. select "Exit" from the Finish Route Build dialog


RAYFAQ#
Find all posts by this user
Thread Closed 


Messages In This Thread
Dock to Dock autorouting with MFDs running LightHouse II software - Chuck - Raymarine - Moderator - 05-14-18 09:15 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)