The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Instruments v / (DG) Triducer installation

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
(DG) Triducer installation
05-20-18, 03:57 AM (This post was last modified: 05-24-18 06:37 AM by Derek - Raymarine - Moderator.)
Post: #1
mwalsh7 Offline
Junior Member
**
 		Posts: 4
Joined: Apr 2018
Reputation: 0
(DG) Triducer installation
I have just installed the thru hull for my triducer and am little confused by which 0-rings i should have on. I believe it is the DST800V that I have as the housing has the flap that closes over and the insert does not have the ribs that the older model has. However the insert has a black O-ring at the top and the yellow one mentioned in the instructions is in the box. Should I be removing the black o-ring and putting the yellow in its place? See attached picture
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
(DG) Triducer installation - mwalsh7 - 05-20-18 03:57 AM
RE: (DG) Triducer installation - stanb - 06-28-18, 08:50 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication