The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] Axiom 9 to Airmar b744v transducer connection issue
05-20-18, 03:06 PM (This post was last modified: 05-22-18 12:49 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Axiom 9 to Airmar b744v transducer connection issue
Ok I finally got the correct Axiom 9 with sonar capability. I have not yet been able to haul the boat to install the RV transducer. In the mean time I was hoping to use my already installed airmar b744v transducer. I have purchased the appropriate Y-cable as well as the 7 pin to dsm300 adapter cable. I hooked everything up but the Axiom does not detect any sonar connected. The airmar transducer worked fine with the previous C90w/dsm300 setup. What could be the problem here? Is there a way to diagnose the transducer by testing between different pins for ohms/resistance values? Is it possible that the RV transducer needs to be connected as well to complete some internal circuit? Thanks again for your help
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Axiom 9 to Airmar b744v transducer connection issue - Rcfiftyone - 05-20-18 03:06 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)