Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] NMEA 2000 and Axiom 9
05-30-18, 09:06 PM (This post was last modified: 05-31-18 08:30 AM by Chuck - Raymarine - Moderator.)
Post: #10
RE: [CA11] NMEA 2000 and Axiom 9
Chuck

I just wanted to follow up with how I left off on this issue. I did discover that the correct engine data was already on the network the entire time and immediately populated the Axiom's Dashboard page when I selected it. I did not need to identify the engines after all.

I do notice that I lose water temperature and depth data from the Axiom's RV-100 when the engines are running. I used your recommendation and purchased the Actisense NGT-1. I was able to determine that the Smartcraft data is also publishing NMEA sentences that are overwriting the Axiom so it seems I have a conflict of PGN.

While searching the subject online I see that some of the Raymarine MFD users have experienced the same conflict reaching out for help 2-3 years ago. Has there been any changes since then? I noticed that multiple data input selections for MFD's would be the easiest solution. Was this feature ever implemented or considered with Raymarine products before I need to go down the engine OEM road?

Bill
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] NMEA 2000 and Axiom 9 - will40 - 05-22-18, 05:04 PM
RE: [CA11] NMEA 2000 and Axiom 9 - will40 - 05-30-18 09:06 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)