[CA11] CPT-200 Blurred Water Area

[Chuck - Raymarine - Moderator]

Welcome back to the Raymarine Forum Tom,

In practice, we have found that the CPT-200's elements typically yield the best imaging when positioned in the middle setting. I have seen similar imaging on my own vessel when the CPT-200 has kicked up. It is recommended that the CPT-200 be inspected to ensure that it is in the correct orientation. If properly positioned and should the problem persist, then it would be recommended that the CP200 be switched OFF, and then ON again. After doing so, the system should be tested when operating at trolling speed with submerged structure abeam (on the side of the vessel on which the transducer is installed) and within 100' of the vessel.

Should the problem persist, then please add another photo of the imaging produced by the CP200 when operating as described above.