Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] PROBLEM WITH ES97
06-13-18, 01:34 PM
Post: #2
RE: [CA11] PROBLEM WITH ES97
Welcome to the Raymarine Forum DFMott,

SeaTalkng communications circuitry failures are a relatively rare occurrence within Raymarine products. It is recommended that the backbone be inspected to ensure that two, and only two SeaTalkng termination plugs have been installed within the backbone, one within each of the backbone's two end sockets. Each of the spur cables should then be unplugged from the spur socket of the backbone and device, re-seated in the sockets, and the locking rings located into the locked position. The SeaTalkng / NMEA 2000 networking components should also be inspected for any signs of damage or modification and replaced if any is evident. When powering a SeaTalkng / NMEA 2000 backbone, it is considered a best installation practice to power the SeaTalkng / NMEA 2000 backbone with a SeaTalkng Power Cable which has been connected to a dedicated, switched 12VDC power circuit and has then been connected to a spur socket located at the approximate midpoint of the backbone's LEN load. If so, then verify that the SeaTalkng Power Switch of the ACU-200 has been switched OFF. We don't generally recommend using an ACU-200 as the power source for a SeaTalkng backbone featuring more than one device in addition to the autopilot's components.

Verify that all product drain leads / terminal have been addressed per the FAQ found here.

As the system features more than one source of GPS data, it is recommended that the MFD's Data Sources feature be exercised to manually specify that the Raystar 150 GPS Sensor be used as the system's data source for GPS data as well as for date/time data. The system should then be connected to shore power and the batteries be permitted to fully charge. After attaining a fully charged state and while still connected to shore power, the system should be tested in a quiet ship state (all other electrical systems, engines, generators, inverters, etc. switched off. Should the problem persist, then verify that all devices which you have listed have been updated with the latest software. If so and the problem persists and the About System diagnostics feature of the p70 lists all of the other devices on the SeaTalkng / NMEA 2000 backbone, then it would be recommended that the MFD be sent to Raymarine’s Product Repair Center to be bench checked / serviced.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] PROBLEM WITH ES97 - DFMott - 06-09-18, 03:06 AM
RE: [CA11] PROBLEM WITH ES97 - Chuck - Raymarine - Moderator - 06-13-18 01:34 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)