The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.3.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Retransmit AIS data from NMEA0183 to e95 on the SeatalkNG network
06-09-18, 08:52 AM (This post was last modified: 06-13-18 01:52 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Retransmit AIS data from NMEA0183 to e95 on the SeatalkNG network
I have a mix of Seatalk and SeatalkNG devices that I gradually want to replace.

Currently I have an AIS connected to the e95 (Lighthouse II, R19) via NMEA0183. The AIS only supports NMEA0183 and I don’t want to replace my AIS. The e95 is connected to a SeatalkNG network with a couple of i70 among others.  

* The AIS is connected to the e95 through NMEA 0183
* The e95 and one i70 are connected to a SeaTalk to SeaTalk NG converter on the STNG device ports
* The old Seatalk network is connected to the Seatalk port on the SeaTalk to SeaTalk NG converter
* On the Seatalk network the following devices are conntected:
- ST60 Speed,
- ST60 Depth,
- i60 Wind,
- Wind transducer,
- Logg transducer,
- Depth transducer,
- RN300 GPS,
- ST6001,
- SmartPilot S2G,
S100 Remote

Is there any way to retransmit the AIS data from the AIS through the e95 onto the SeatalkNG network so I can show AIS data on the i70?

Want to keep using my AIS that I like and spend my money on gradually upgrading to SeatalkNG and install i70S displays. the ITC-5 and later a new Autopilot instead of replacing the AIS.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Retransmit AIS data from NMEA0183 to e95 on the SeatalkNG network - JonasE - 06-09-18 08:52 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)