Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Dragonfly 7 Pro CPT-DVS transducer installation
06-26-18, 11:07 AM (This post was last modified: 08-29-18 09:05 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] Dragonfly 7 Pro CPT-DVS transducer installation
Welcome to the Raymarine Forum Regal2100LSR

Q1. 1. Can the cable be cut to pass though the transom so I only need to drill a small [censored] for the cable? Otherwise, I would need to drill a 7/8 inch [censored] to pass the connector through. I have good soldering skills to splice the cable back together after passing though. However, I want to get advice on whether the cut and splice will affect the operation of the transducer? I will need all to the 20 foot cable length to route it between the mounting location and the helm.
A1. Please click here to view a FAQ addressing this subject.

Q2. Where should I mount the transducer? I have attached a photo for reference. I was thinking the flat spot just to the left of the far right side bunk shown in the photo (behind right tie down strap). Is that a better location since it is flat rather than in the V portion of the hull closer the the speedometer pickup also shown in the photo? I am guessing the sonar footprint will be less impeded in the flat location?
A2. The area to the right of the speed pitot tube which is also to left of the first chine to starboard would typically be recommended. Should the vessel feature Regal's FasTrac hull design, then it may be a challenge, if at all possible, for a transom mounted transducer to to maintain bottom contact while operating at planing speeds. Please click here to view a FAQ addressing this subject.

Q3. So here is the strange question. Ideally I may want to mount the Dragonfly either in front of the captain's seat where it is now for some trips, or in front of the first mate's seat on the port side for other trips. I would wire two separate connectors to accomplish this. The power is easy. However the sonar cable would have to be routed with separate cables down the port side of the boat for the first mate location, verses starboard side for the captains location. So the question is: is it possible to either split the wire near the transom in the engine compartment, or install a connectors to switch between cables?
A3. Negative. If seeking to install a single transducer and then install the display in two mounting locations, this would not have been the product which would have been recommended. Instead, an Axiom MFD or a-Series MFD which had been interfaced to a HS5 RayNet Network Switch along with a CP100 DownVision Sounder Module w/CPT-100 DownVision Transducer would have been recommended for this application. Separate power cables would have been installed at each desired mounting location for the display, along with a RayNet (F) to RayNet (F) Cable linking each mounting location to the HS5 RayNet Network Switch.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
RE: [CA11] Dragonfly 7 Pro CPT-DVS transducer installation - Chuck - Raymarine - Moderator - 06-26-18 11:07 AM

Forum Jump:

User(s) browsing this thread: 1 Guest(s)