The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] T122 Not Sending Data to Garmin 942xs & Remote Issue
07-03-18, 01:02 PM (This post was last modified: 07-24-18 09:23 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] T122 Not Sending Data to Garmin 942xs & Remote Issue
Problem 1
I have a T122 that I believe is wired correctly to send data to a New Garmin 942xs Chartplotter. The T122 is receiving data but not sending. All ports on Garmin 942xs are set to NMEA Standard 0183.

During original install with an old Garmin Chartplotter I recall the Marine Electrician plugging his computer into the T122. Could he have changed a setting or two creating the problem? If so is there a way to fix the issue without being a computer/electronics expert?

please see diagram attached.

Problem 2
I recently bought (2) NEW T111 Displays. During "Networking" the new T111s woke up and connected to the Micronet just fine and display data.
However:
Before adding these NEW displays I had (3) Existing Displays, (2) T215 and (1)T111, named #1, #2 and #3 by the T113 Remote. After adding the NEW Displays the T113 Remote now shows Display names #1, #2 and #4. Further the NEW Displays cannot be controlled by the remote. What can i do to get the (2) NEW T111s to be able to be operated by the T113 Remote? All components are branded Raymarine.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] T122 Not Sending Data to Garmin 942xs & Remote Issue - agurski - 07-03-18 01:02 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)