Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] Trip distance settings
07-16-18, 08:46 PM
Post: #4
RE: [TG11] Trip distance settings
Hmm. If you've only looked at this dockside/on the trailer, I suspect that it will start working when you get underway: I think thta Trip data is only sent out when the value changes. If that turns out not to be it, maybe the system hasn't remembered the transducer selection for the speed data (of course it ought to), or perhaps something else is overriding the trip data (not unknown).

- If you bring up a Speed databox (not SOG), does that show valid data, zeroes or dashes when underway?
- What shows in Speed data-sources in Home > Setup > System Settings > Data Sources > Speed?
- What is the Speed transducer selection in the Fishfinder page's setup menu?

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [TG11] Trip distance settings - Tom - Raymarine - Moderator - 07-16-18 08:46 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)