Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] Replace RayPilot650/CC100 with Type1 Pump
07-17-18, 05:19 PM (This post was last modified: 07-19-18 12:06 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] Replace RayPilot650/CC100 with Type1 Pump
Welcome to the Raymarine Forum GadgetBob42,

The currently installed drive unit and rudder referenced unit may be retained for use with an Evolution autopilot. Should the vessel feature a 12VDC power distribution system, then it would typically be recommended that a T70407 EV-150 Core Pack be purchased. Should the vessel feature a 12VDC power distribution system, then it would typically be recommended that a T70156 EV-200 Power be purchased Within a system such as you have described, it would typically be recommended that a powered and properly terminated SeaTalkng / NMEA 2000 backbone be created to interface the Evolution autopilot components. The backbone should be constructed to have have at least one extra spur socket to accommodate interfacing the computer to the backbone via an NMEA 2000 to PC interface (ex. Actisense NGT-1) ... assumes that TimeZero supports NMEA 2000 communications. The backbone would additionally feature a SeaTalk to SeaTalkng Converter to accommodate interfacing the SeaTalk bus (RL80C) to the backbone. A switched NMEA 0183 interface between the PC and the RL80C may be maintained to support waypoint/ route transfer.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Replace RayPilot650/CC100 with Type1 Pump - Chuck - Raymarine - Moderator - 07-17-18 05:19 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)