Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] iTC-5 Compatibility
07-17-18, 04:36 PM
Post: #2
RE: [CA11] iTC-5 Compatibility
Welcome to the Raymarine Forum Tom,

Depth, speed, and temperature transducers which had bee designed for use with ST40, ST50, ST50+, ST60, ST60+, and ST290/ST70 instrument pods should indeed be compatible with an iTC-5. Following installation of the system it would be necessary to use the i70's Transducer Set-up feature to select the iTC-5 and then configure depth and speed (temperature calibration is performed via the speed configuration options). Speed sensors must be calibrated. It is also recommended that you ensure that iTC-5, as well as the other system components, have each been updated with the latest available Raymarine product software updates. Should there be a concern that the speed transducer may have suffered a failure, then please click here to view a FAQ addressing how it may be tested. Should there be a concern that the temperature transducer may have suffered a failure, then please click here to view a FAQ addressing how it may be tested.

Should the above listed items have been addressed and no fault be found with the transducers, then it would be recommended that the iTC-5 be sent to Raymarine’s Product Repair Center to be bench checked / serviced.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] iTC-5 Compatibility - taylort100 - 07-17-18, 02:23 PM
RE: [CA11] iTC-5 Compatibility - Chuck - Raymarine - Moderator - 07-17-18 04:36 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)