[TG11] Autotack user cal on ST6002 SmartPilot Controller

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[TG] [TG11] Autotack user cal on ST6002 SmartPilot Controller

07-25-18, 10:28 PM (This post was last modified: 07-27-18 12:29 PM by Chuck - Raymarine - Moderator.)

Post: #2

Tom - Raymarine - Moderator Offline

Administrator

Posts: 1,067
Joined: Nov 2017
Reputation: 7

RE: [TG11] Autotack user cal on ST6002 SmartPilot Controller

Hello David,

Sorry for the delay replying.

This, I'm sorry to say, an SPX pilot limitation: the SPX pilots didn't support a manual/fixed tack angle. There was an error in the handbook that said that they did (I have a feeling that that was corrected in a later issue of the handbook, but haven't checked back.)

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.

« Next Oldest | Next Newest »

Messages In This Thread

[TG11] Autotack user cal on ST6002 SmartPilot Controller - tyed - 07-21-18, 03:00 PM

RE: [TG11] Autotack user cal on ST6002 SmartPilot Controller - Tom - Raymarine - Moderator - 07-25-18 10:28 PM

RE: [TG11[ Autotack user cal on ST6002 SmartPilot Controller - tyed - 07-27-18, 09:35 AM

RE: [TG11] Autotack user cal on ST6002 SmartPilot Controller - Tom - Raymarine - Moderator - 07-29-18, 09:02 PM

User(s) browsing this thread: 1 Guest(s)