Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] Sounder for catamaran
08-14-18, 12:26 AM
Post: #2
RE: [TG11] Sounder for catamaran
Hello Guy,

The current equivalent of an E90W is a display called an Axiom Pro 9 http://www.raymarine.com.au/multifunctio...axiom-pro/. There are two versions, the Pro-S and Pro-RVX. The Pro-S is aimed at cruising, the RVX at fishing, so I'd go the Pro-S with a CPT-S depth transducer connected. We offer the CPT-S transducers in transom-mount or tilted-element low-profile through-hull variants: you should use through-hull rather than transom-mount. Exactly which through-hull you get depends on the dead-rise of the hull area where you need to mount the transducer - the tilt helps to get the transducer beam pointing vertically at the bottom.

You can connect ST60 instruments to new displays via a Seatalk1-SeatalkNG convertor, but I think I would leave the ST60 Depth at least disconnected from the new display, mount the new depth transducer in the starboard hull, and use the new depth transducer as the primary depth reference but have the ST60 Depth as a standalone backup/port-hull reading. You cannot have two different depth readings in a single system which is the reason for leaving the ST60 Depth isolated from the new Axiom Pro. You should connect the ST60 Speed to the new display via one of the convertors if possible.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [TG11] Sounder for catamaran - Tom - Raymarine - Moderator - 08-14-18 12:26 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)