Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] RV300 - placement
09-23-18, 10:01 PM
Post: #2
RE: [TG11] RV300 - placement
Hello Watsala,

This isn't something we'd generally recommend, but from an acoustic point of view I don't think it will cause a problem. You will need to make sure that the outboard edge of the transducer is supported outside the hull, and that the nut/locking ring is also supported inside so that the surfaces that the transducer and locking ring clamp are parallel. I am assuming that this is what you plan, it's just not on shown on your drawing.


Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
[TG11] RV300 - placement - watsala - 08-07-18, 04:38 AM
RE: [TG11] RV300 - placement - Tom - Raymarine - Moderator - 09-23-18 10:01 PM

Forum Jump:

User(s) browsing this thread: 1 Guest(s)