The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.3.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG11] DSC Acknowledgement not received
08-10-18, 04:35 AM (This post was last modified: 08-16-18 09:13 AM by Chuck - Raymarine - Moderator.)
Post: #1
[DG11] DSC Acknowledgement not received
I have a brand new RAY70 VHF radio.

Everything else with it works perfectly, but as I tested it with the local cost station and another boat in my marina, the DSC call function does not work properly. It sends out the DSC individual call, but then when the other station responds the response is never received at the RAY70.

One exception so far, a hand held radio worked perfectly with my RAY70 when tried from about 50 meters away. The other boat was in the same location and it's fixed radio did not work.

Things that I've checked so far:
- The antenna. SWR was measured and it was found out that it works perfectly, also the AIS is able to receive vessel information from 30-40 NM away, and I can now also receive foreign cost station SECURITE calls on channel 16 over 50 miles away. So the antenna should not be an issue.
- Sensitivity is set to Distant
- Software was checked and is the latest version, both the bootcode and the application.

The setup: The radio is connected to a Seatalk NG network together with an Axiom 9 MFD and a i70 display. Also in the network is the sonar transducer and the log/temperature sensor.

So what to check for next ?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[DG11] DSC Acknowledgement not received - PetriS - 08-10-18 04:35 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)