Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Installing back bone
04-22-16, 09:44 AM (This post was last modified: 04-22-16 09:56 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: Installing back bone
Welcome to the Raymarine Forum Goldog,

Raymarine offers spur to DeviceNet and Spur to bare cables to support use with third party cables. It is indeed recommended that both a powered and properly terminated Suzuki backbone and a powered and properly terminated SeaTalkng backbone be installed onboard the vessel. The Suzuki engine would be interfaced as a spur to the Suzuki engine backbone and the MFD would be interfaced as a spur to the SeaTalkng/NMEA 2000 backbone. A spur from each backbone would then be interfaced to a third party NMEA 2000 engine gateway (recommend contacting Suzuki) to pass engine data from the Suzuki backbone to the SeaTalkng/NMEA 2000 backbone. Please click here to view a FAQ additional information addressing this subject.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Installing back bone - Goldog - 04-21-16, 11:56 AM
RE: Installing back bone - Chuck - Raymarine - Moderator - 04-22-16 09:44 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)