[DG] [DG] Instruments and E90 MFD not sharing data and ST6001 SeaTalk Fail
|
08-17-18, 02:36 PM
(This post was last modified: 08-20-18 09:51 AM by Derek - Raymarine - Moderator.)
Post: #1
|
|||
|
|||
[DG] Instruments and E90 MFD not sharing data and ST6001 SeaTalk Fail
Hi All,
I have been working this problem for over a week and need your help. I first noticed issues with instruments with a message Seatalk Fail on my ST6001. About the same time as a SeaTalk failure with my ST6001, I also noticed a problem with data sharing between my ST60 instruments and between the autopilot and E90’s. Each instrument is functioning on its own, but some if not all data does not seem to be shared between other nodes on the SeaTalk1 bus. I am looking for any assistance on how to proceed. So far, I have checked all the connections. I replaced the ST6001 with a new P70S and the autopilot control now works and is commissioned. Here is my setup: (see attached diagram) E80 MFD at the helm E80 MFD at the chart table SeaTalk HS network switch for each E80 ST60 Tridata for depth and speed ST60 Wind Raymarine SeaTalk auxiliary Junction box S3 Smartpilot Course Computer P70S Autopilot Control Head (new) The conditions I have observed are: On the ST60 Wind Instrument, there is No True wind speed indication - only reading dashed lines. Apparent wind speed is OK. Wind Direction is OK for apparent ST60 Tridata – Depth and speed display fine. On the E90 there is No wind vector available at the E90. The E90 also is not reading the ST60 alarms (example: low depth alarm). I can no longer acknowledge a depth alarm from the E90. I can, however, set a Goto waypoint on the E90 and track this on the P70S. On the new P70S there is no reading of the depth. I also have 12 volts from red to shield There are about 11 volts on the yellow to shield measured using an accurate volt meter. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[DG] Instruments and E90 MFD not sharing data and ST6001 SeaTalk Fail - PDReynolds - 08-17-18 02:36 PM
|
User(s) browsing this thread: 1 Guest(s)