Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Calibration question
09-12-18, 02:55 PM
Post: #2
RE: [CA11] Calibration question
Welcome to the Raymarine Forum Jeff,

Full calibration includes not only successfully turning the vessel to establish the magnetic deviation table to be used in determining magnetic heading, but also successfully completing the Auto Learn step. The Auto Lear step permits the autopilot to learn the vessel's handling characteristics while it automatically steers the vessel through a succession of turns. Should either of these not be completed, then the reported message will be displayed each time that the system is powered ON. In addition to these steps it is also recommended that after successfully turning the vessel to establish the magnetic deviation table, that the autopilot's compass be aligned to a known magnetic bearing or to COG (the latter requires that the vessel be underway and steered on a constant heading at a speed of 5 kts or greater, preferably while not under the influence of leeway).
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Calibration question - Chuck - Raymarine - Moderator - 09-12-18 02:55 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)