The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] Upgrade pump on S1 course computer

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Upgrade pump on S1 course computer
09-25-18, 09:29 AM (This post was last modified: 09-25-18 11:27 AM by Chuck - Raymarine - Moderator.)
Post: #1
HappyHarry Offline
Junior Member
**
 		Posts: 1
Joined: Sep 2018
Reputation: 0
[CA11] Upgrade pump on S1 course computer
Hey guys,
Recently, I disassembled a complete autopilot set from another boat to be built into our boat.
These are: Raymarine (12 volts) ST8002, S1 computer, Compass, Gyro, Type 1 pump and Rudder sensor.
Since my steering cylinder is 650 cc, I think of a heavier pump like Type 3 but it can't be connected to the S1, according the manual.
Is there another solution to upgrade the pump with S1?
The only thing I can think of is a reversing relay between S1 and pump but is that possible, I don't know what the A and B ports gives, a steady voltage?
Thanks.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Upgrade pump on S1 course computer - HappyHarry - 09-25-18 09:29 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication