Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] e95 MFD won't boot
10-03-18, 11:23 PM
Post: #4
RE: [TG11] e95 MFD won't boot
Hello John,

A voltage drop of around 0.6V from the no-load state when a 10W load is applied implies that you'll get around 1.2V - 1.5V drop when the e95's 18W load is applied, which is a lot and much more that you ought to have, but still leaves the e95 likely to have at least 11V, which is far from ideal but should be enough. Product reliability and speed drops as the supply gets marginal, but it should start up.

Based on that info, I think you should get the display checked at a service centre or by your nearest technical dealer. How to buy > Locate a Dealer on our website will show dealers near you, though different Raymarine offices around the world indicate Service dealers slightly differently: here in Australia we use the Certified Installation check-box.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[TG11] e95 MFD won't boot - JohnRE - 09-26-18, 07:35 PM
RE: [TG11] e95 MFD won't boot - JohnRE - 10-01-18, 06:57 PM
RE: [TG11] e95 MFD won't boot - Tom - Raymarine - Moderator - 10-03-18 11:23 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)