[CA] [CA11] St2000+ connected to CSx76 Garmin

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum Salvo,

Please be certain the CSx76's Power/Data Cable has been interfaced to the ST2000+ as follows:
- CSx76's Power/Data Cable's DATA OUT (brown) lead has been interfaced to the ST2000+'s NMEA 0183 IN+ (white) terminal; and
- CSx76's Power/Data Cable's GROUND (black) lead has been interfaced to -12VDC and to the ST2000+'s NMEA 0183 IN- (green) terminal; and
- CSx76's Power/Data Cable's Power (red) lead has been interfaced to +12VDC.

After having performed the above connections, the CSx76's Advanced NMEA Setup page (see the CSx76's Owner's Manual) should be accessed via the CSx76 to ensure that the following have been selected:
- GPS Status
- Waypoint/Route
- Autopilot Mode

The Garmin Proprietary option within the Sx76's Advanced NMEA Setup page may remain unchecked.

Command the GSx76 to Go To Waypoint/Cursor Location or to Follow a Route. After doing so, the corresponding NMEA 0183 autopilot sentences, along with GPS data, should be sent to the autopilot, permitting it to be commanded into Track mode.