MyBB Internal: One or more warnings occured. Please contact your administrator for assistance.
[CA11] i70s and rudder angle gauge display not available


Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] i70s and rudder angle gauge display not available
09-30-18, 02:36 PM (This post was last modified: 10-01-18 09:46 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] i70s and rudder angle gauge display not available
My i70s won't allow me to set up a display with a rudder angle gauge on it. I can select the numerical rudder angle, and that works fine and shows data, but the two different "gauge" displays for rudder angle are grayed out and if I try to select them it beeps angrily at me.

I have an S1 autopilot with rudder position sensor attached to it, running SeaTalk1 to two ST50+ (wind and depth) and the ST6001+ autopilot head. Depth/Wind/Speed transducers are connected to an ITC-5, which is connected to the i70s and to the ST6001+ via a SeatalkNG-Seatalk1 junction.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] i70s and rudder angle gauge display not available - tmarks11 - 09-30-18 02:36 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)