The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Instruments v / [CA] [CA11] splicing old seatalk

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] splicing old seatalk
10-11-18, 11:49 AM (This post was last modified: 10-11-18 12:52 PM by Chuck - Raymarine - Moderator.)
Post: #1
ritchardfindlay Offline
Junior Member
**
 		Posts: 4
Joined: Mar 2016
Reputation: 0
[CA11] splicing old seatalk
Hi,

I have been searching the forum and can't find the answer to this kind of old question.

I just got a new SeatalkNG pilot, and want to interface it with my old ST60 instruments. I have a Seatalk>SeatalkNG converter.

What I would like to know is if I can splice into my existing Seatalk network in order to provide data to the converter. I have three ST60 instruments at the help and an ST60 Graphic Display at the mast. The Graphic Display is the only open Seatalk port. It's quite a big deal to run a cable from that display to the rear of the boat where the EV-1 and ACU will reside.

Oh, one more thing. Back in the day of fluxgates, I believe you were to mount them on the centerline of the boat if possible. Am I okay to mount the new EV sensor toward the rear of the boat and a couple feet off center?

Thanks in advance,

RF
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] splicing old seatalk - ritchardfindlay - 10-11-18 11:49 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication