The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.3.30 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] no seatalk from a128
10-13-18, 07:21 PM (This post was last modified: 10-15-18 12:53 PM by Chuck - Raymarine - Moderator.)
Post: #1
[TG11] no seatalk from a128
Hi all,

I recently took a lightning strike and replaced my autopilot with a new ev-200. My a128 mfd seemed to be fine, but when I add it to the network it only sees itself. It is odd as the data it gets from my vhf/ais radio shows the ais targets but there is nothing coming through ST ng.

I have a similar issue with the i70 instrument, but when I hook that in to the system the autopilot head shows no autopilot and the ev-1 goes into red blink which is no seatalk. I am pretty sure this is toast.

The a128 will obviously operate but can not integrate into the ev-200 since it can not be seen on the network. (if i do a diagnostic - select device from the p70s it does not see the a128)

So is there another way to be able to pass data or get this thing fixed? It seems a shame if I have to replace just because of the networking.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[TG11] no seatalk from a128 - firstlight38 - 10-13-18 07:21 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)