The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] ST70 Speed Calibration
10-16-18, 06:07 AM (This post was last modified: 10-16-18 12:43 PM by Chuck - Raymarine - Moderator.)
Post: #1
[TG11] ST70 Speed Calibration
I am having difficulty calibrating STW using an ST70 display. The speed transducer is Airmar and its connected to an iTC-5. I also have 2 x Axiom 7's in the network. In reading the ST70 manual it initially makes reference to starting the calibration at the lowest calibration speed of 2 KTS (Start Speed Calibration item 6). I did this and needed to use the maximum calibration factor of 2.0 but even then it was reading a little low. I then moved to 4KTS and needed to use a factor of 0.9. On For the 8KTS factor I motored at my maximum speed of 7.5KTS SOG but even when using a factor of 2.0 I could not get STW reading high enough. What might I be doing wrong?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[TG11] ST70 Speed Calibration - andrewlachlan - 10-16-18 06:07 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)