Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Connect Yamaha 175 to Axiom 9
01-28-19, 11:08 AM (This post was last modified: 01-28-19 11:09 AM by Chuck - Raymarine - Moderator.)
Post: #4
RE: [CA11] Connect Yamaha 175 to Axiom 9
natedawgsem,

No settings need be configured on the MFD regarding the missing data items. This is quite likely a limitation of the Yamaha NMEA 2000 engine gateway or that of the engine itself (i.e. some engine systems may only output a subset of the total list of engine data items supported by the engine gateway). As data from the engine is being displayed by the MFD, it would appear that the products have been correctly interfaced. You may want to consult with Yamaha regarding whether your engine in conjunction with the chosen engine gateway will transmit the missing data items you have specified to a NMEA 2000 backbone. If so, then it would be recommended that a NMEA 2000 bus analyzing tool (ex. Actisense NGT-1-USB w/Actisense NMEA Reader PC software, etc.) be interfaced as a spur device to the SeaTalkng / NMEA 2000 backbone to monitor and obtain detailed information concerning the system's SeaTalkng / NMEA 2000 communications.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Connect Yamaha 175 to Axiom 9 - Chuck - Raymarine - Moderator - 01-28-19 11:08 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)