Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Quantum Radar not found
12-17-18, 09:08 AM
Post: #6
RE: [CA11] Quantum Radar not found
Mike,

Many are not aware that the design of the wired Quantum radome features two Wi-Fi transmitter/receivers. One is connected to the radome's wired communications interface and the other is identical to that which W-Fi - only Quantum radomes have. When interfaced to the Quantum radome via a communications cable, commands and data are passed between these Wi-Fi communications interface. It is quite possible that the root of the problem which you are experiencing with the Quantum is within its Wi-Fi receiver that is common to Wi-Fi - only Quantum radomes. Should a Quantum radome have been interfaced to the system via a communications cable, then it would be necessary to disconnect the Quantum communications cable from the MFD or network switch and then perform a Settings Reset or Factory Reset to clear knowledge of the radome from the memories of the system's MFDs. One may then attempt to pair a MFD (the one which is in closest proximity to the Quantum and/or surrounded by the least structure would be recommended) with the Quantum radome. Afterwards, whenever desiring to utilize radar features, this MFD must be switched ON.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Quantum Radar not found - Chuck - Raymarine - Moderator - 12-17-18 09:08 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)