Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[LW] [LW11] SeatalkNG to Seatalk HS Switch
01-09-19, 05:09 PM (This post was last modified: 01-10-19 11:47 AM by Chuck - Raymarine - Moderator.)
Post: #6
RE: [LW11] SeatalkNG to Seatalk HS Switch
hadjiosif,

The final release of E-Series Classic MFD software (v5.69) introduced limited support for SeaTalkng / NMEA 2000 communications. Such support included communications with Raymarine autopilots, instruments, and GPS sensors featuring a SeaTalkng communications interface and some types of third party NMEA 2000 devices (ex. NMEA 2000 engine gateways, etc.). Accordingly, it would be recommended that this interface be used for interfacing an E-Series Classic MFD to products such as a Raystar 150/130 GPS Sensor, Evolution/SPX autopilot components, i50/i60/i70/ST70 instruments, etc.. However, this update did not include the software required to process NMEA 2000 PGNs associated with AIS data. As indicated within my previous post and the referenced FAQ, AIS receivers and transceivers must be interfaced to A/C/E-Series Classic MFDs via the MFD's NMEA 0183 communications interface. The good news is that unlike most third party AIS receivers and transceivers, Raymarine's AIS 350, AIS650, and AIS700 feature a 38400 to 4800 BAUD bidirectional bidirectional NMEA 0183 multiplexer to address situations such as yours, where the MFD has already been or will need to be interfaced to other devices having a 4800 BAUD NMEA 0183 communications interface.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [LW11] SeatalkNG to Seatalk HS Switch - Chuck - Raymarine - Moderator - 01-09-19 05:09 PM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)