The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.3.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error

Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Axiom not holding transducer setting
01-07-19, 09:20 PM (This post was last modified: 01-08-19 03:59 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Axiom not holding transducer setting
Good evening,

I have two networked axioms, a 12" pro and a 12" non-pro. Last week, got on the boat and noticed that my sonar high chirp did not look correct. Went into the transducer settings and noticed that it listed my "RV thru-hull transducer not my airmar transducer. Was able to switch it to the airmar and everything worked fine. If I change the display to another app such as chart and then return to the sonar screen, the transducer resets to my RV ducer. I can change it again but it will not hold at all when switching apps. This is a new problem and no update was done in between the time when it worked and then it didn't work. The boxes are on the latest rev of lighthouse software. Please advise.

Thanks in advance.
Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
[CA11] Axiom not holding transducer setting - avetjx - 01-07-19 09:20 PM

Forum Jump:

User(s) browsing this thread: 1 Guest(s)