The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] ST2000+ not heading correctly in track mode
01-17-19, 04:02 PM (This post was last modified: 01-17-19 04:12 PM by Chuck - Raymarine - Moderator.)
Post: #1
[TG11] ST2000+ not heading correctly in track mode
Hi There,
I have an ST2000+ tiller pilot interfaced (by via ST1 to STNG converter) with ST60+ instruments and an A70D Plotter/MFD.
Communication seems to be working ok, pilot pop ups appear on the ST60 displays and wind and track data appear on the ST2000+ When it is in the appropriate modes.

I can set up a route or waypoint and enter in to track mode ok.
However, I have noticed one glitch when the autopilot is in track mode.

Although BTW, Heading and COG all appear to be sensible, the autopilot seems to want to head 10-15 degrees to port of the BTW. I have tried this on a range of track headings.
I suspect that the error is that magnetic variation (about 13E here) is being applied once too often somewhere in the system.
I have variation in auto on the ST 60+ Graphic and on the A70D plotter.

Could you please advise the correct variation settings for each instrument/display and let me know if there are any other configuration changes I should check out and correct?
I am planning further test in the next few days, so if there’s anything I need to do to get you more data to work with please let me know.
Regards
Dave Davies.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[TG11] ST2000+ not heading correctly in track mode - dave.squared@hotmail.com - 01-17-19 04:02 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)