Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Thermal Camera Monitor
02-06-19, 09:53 AM
Post: #2
RE: [CA11] Thermal Camera Monitor
Welcome to the Raymarine Forum tegarre,

Please note that E-Series Classic MFDs are not designed to control or configure thermal cameras. The first Raymarine MFD design to offer such capability was the E-Series Widescreen MFDs. Accordingly, the T200 thermal camera will not be interfaced via Ethernet (SeaTalkhs) to the MFD. The T200 would need to be interfaced via Ethernet to a Raymarine Joystick Control Unit (JCU). However, the NTSC/PAL video output of the T200 may be interfaced to the Video Input Cable supplied with the E-Series Classic MFDs to permit viewing of the thermal imagery video from the T200. If seeking a monitor, for the T200, one featuring support for NTSC/PAL video input would be required.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Thermal Camera Monitor - tegarre - 02-05-19, 08:14 PM
RE: [CA11] Thermal Camera Monitor - Chuck - Raymarine - Moderator - 02-06-19 09:53 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)