[DG11] Tinning Wires to Course Computer

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[DG] [DG11] Tinning Wires to Course Computer

03-13-19, 04:55 PM (This post was last modified: 03-14-19 06:10 AM by Derek - Raymarine - Moderator.)

Post: #1

PHINNROS Offline

Older Sailor and Builder

Posts: 11
Joined: Feb 2019
Reputation: 0

[DG11] Tinning Wires to Course Computer

Having worked in industry for a number of years there is always a question when inserting stranded wires into terminals if they should be tinned so they are solid.
So the questions is; should the wires from the rudder sensor, fluxgate compass, SeaTalk, power, motor and clutch be tinned or should they be left stranded. I see no mention of what would be best practice in the installation manual.

« Next Oldest | Next Newest »

Messages In This Thread

[DG11] Tinning Wires to Course Computer - PHINNROS - 03-13-19 04:55 PM

RE: [DG11] Tinning Wires to Course Computer - Derek - Raymarine - Moderator - 03-14-19, 06:48 AM

RE: [DG11] Tinning Wires to Course Computer - PHINNROS - 03-16-19, 04:29 PM

RE: [DG11] Tinning Wires to Course Computer - Derek - Raymarine - Moderator - 03-18-19, 07:22 AM

User(s) browsing this thread: 1 Guest(s)