The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Networking / System Integration v / [CA] [CA11] Integrating A70 Plotter and AP ST 4000 +

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Integrating A70 Plotter and AP ST 4000 +
03-14-19, 07:07 AM (This post was last modified: 03-14-19 10:18 AM by Chuck - Raymarine - Moderator.)
Post: #1
shero2 Offline
Junior Member
**
 		Posts: 1
Joined: Feb 2019
Reputation: 0
[CA11] Integrating A70 Plotter and AP ST 4000 +
I have been trying to get my A70 plotter to recognise the ST 4000 + Autopilot.

I originally tried running NMEA 183 IN/OUT from the A70 to an ST 60 Multi that is connected to ST1 backbone and I had no luck.

I then tried NMEA 183 from the A70 to the NMEA IN port on the ST 4000 + and no luck.

The manual says if I connect more than 1 NMEA device I need a Seatalk – NMEA 183 converter.

As Raymarine no longer make one I could use an Actisense product.

I am unsure but where I would install it and how I should wire it.

I have not shown it on my very basic diagram but I do have a spare ST1 plug on the ST 60 Multi.

I hope my diagram makes sense and currently power is supplied through the ST 4000+ and am also wondering if I need to supply more power to the backbone ?

I look forward to any suggestions


Attached File(s) Thumbnail(s)
   

.pdf  wiring 1.pdf (Size: 93.47 KB / Downloads: 169)
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Integrating A70 Plotter and AP ST 4000 + - shero2 - 03-14-19 07:07 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication