The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error

Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Wind speed not reporting correctly
03-14-19, 12:49 PM (This post was last modified: 03-14-19 01:19 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Wind speed not reporting correctly
I have an ST60 wind angle, wind vane, RC530 at nav station, RL70C Plus at helm, and tridata.

At anchor, when I first provide power, after the start up dashes go away, the wind angle instrument shows what appears to be correct velocity with blinking pixels under True and App. After a few seconds the pixel under either True or App goes solid and the velocity shown reduces to zero. For example it might show 14, then 6.3, then 4.2, then 0.0. This is reflected on the MFDs.

The wind angle needle shows correctly as does depth and speed on the tridata. Of course at anchor speed is zero.

Electrical signals from the wind vane appear reasonable.

The wind angle and depth show on the MFDs.

As I write this I am thinking that the speed data is not making it to the wind angle instrument and so it is failing to 0.0 wind speed instead of assuming the boat speed of 0.

When underway the results are the same.

Any other ideas about the issue or additional tests to make?

Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
[CA11] Wind speed not reporting correctly - hlev40 - 03-14-19 12:49 PM

Forum Jump:

User(s) browsing this thread: 1 Guest(s)