The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Radar v / [CA] [CA11] RD218 connection - crimp or solder?

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] RD218 connection - crimp or solder?
04-22-19, 11:07 AM (This post was last modified: 04-24-19 02:17 PM by Chuck - Raymarine - Moderator.)
Post: #1
YoBub Offline
Junior Member
**
 		Posts: 6
Joined: May 2018
Reputation: 0
[CA11] RD218 connection - crimp or solder?
I purchased a used RD218, and the previous owner cut the cable to the connector at the array.

I have purchased a new connector that came with new pins, and I'm wondering if I should just crimp the wires to the small pin connectors that go into the black data connector on the array, or if I should solder these?

The pins are really small so it is hard to get the crimps to stay, but I'd like to do it in what ever way will yield the best results.

Thanks!
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] RD218 connection - crimp or solder? - YoBub - 04-22-19 11:07 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication