[TG11] Sounder Supply Voltage Too Low

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[TG] [TG11] Sounder Supply Voltage Too Low

08-06-19, 04:57 PM

Post: #14

Tom - Raymarine - Moderator Offline

Administrator

Posts: 1,067
Joined: Nov 2017
Reputation: 7

RE: [TG11] Sounder Supply Voltage Too Low

Hello John,

There's no adjustable threshold for the alarm to be triggered: the warning is being presented because the display is measuring a supply voltage that is too low for reliable sounder operation. Either that's a genuine and problematic low voltage (e.g. a high-resistance connection somewhere in your power cabling/connections), or it's a problem with the measurement inside the display. If you believe the latter is the case then you should get the display checked by a Raymarine service centre.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.