[CA11] Can't Get Plotter Sync to Work

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] Can't Get Plotter Sync to Work

05-28-19, 08:35 AM

Post: #6

Chuck - Raymarine - Moderator Offline

Administrator

Posts: 14,319
Joined: Oct 2014
Reputation: 43

RE: [CA11] Can't Get Plotter Sync to Work

Welcome to the Raymarine Forum Instigator40,

Raymarine LightHouse 3 software updates are scheduled for release at approximately quarterly intervals. The LH3 v3.9.46 update was released in April 2019. Should one need to utilize this feature sooner than the LH3 v3.10.x software release and not desire to perform the workaround provided by Navionics, then it would be recommended that on consider downgrading the MFD's software to LH3 v3.8.105.

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] Can't Get Plotter Sync to Work - fidlerjim - 05-12-19, 10:50 AM

RE: [CA11] Can't Get Plotter Sync to Work - Chuck - Raymarine - Moderator - 05-13-19, 03:06 PM

RE: [CA11] Can't Get Plotter Sync to Work - fidlerjim - 05-14-19, 09:45 PM

RE: [CA11] Can't Get Plotter Sync to Work - Chuck - Raymarine - Moderator - 05-16-19, 08:17 AM

RE: [CA11] Can't Get Plotter Sync to Work - Instigator40 - 05-27-19, 07:57 PM

RE: [CA11] Can't Get Plotter Sync to Work - Chuck - Raymarine - Moderator - 05-28-19 08:35 AM

RE: [CA11] Can't Get Plotter Sync to Work - Instigator40 - 06-01-19, 06:51 PM

RE: [CA11] Can't Get Plotter Sync to Work - Chuck - Raymarine - Moderator - 06-03-19, 07:42 AM

User(s) browsing this thread: 1 Guest(s)