Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Navionics Chart Data will not load and MFD reboots
05-21-19, 01:10 PM
Post: #2
RE: [CA11] Navionics Chart Data will not load and MFD reboots
Welcome back to the Raymarine Forum Robinsonh2o,

Following the release of LightHouse 3 v3.9.46, Raymarine's engineering team has subsequently recommended that a Power On Reset be performed to each MFD following the software update. This differs from the Factory Reset option found within the MFD's user interface. The procedure for performing the Power On Reset may be found within the Performing a Power On Reset - Axiom Pro section of Chapter 20.3: Power up troubleshooting of the LightHouse 3.9 Advanced Operation Instructions. Before doing so, it is recommended that any valuable waypoint, route, or track data stored within the MFD's memory be backed up, as this operation will erase such data and restore the MFD's settings to their factory defaults. Should the problem persist thereafter, then please respond accordingly.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Navionics Chart Data will not load and MFD reboots - Chuck - Raymarine - Moderator - 05-21-19 01:10 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)