[CA] [CA11] Pathfinder Gain Setting

[thedoublee]

I have a 4kW 48" Pathfinder open array that is hooked up to an RL80C display. I am testing this setup prior to installing. I understand that there are very limited spares and support for these older units.

It is hooked up to a 20A-12V power supply in my backyard (tall wooden fence and 2-story houses on all sides within 50-100' radius). Scanner is sitting on sawhorses on the ground. Display is approx. 20' away inside my workshop. Diagnostics menu seems to indicate that everything is fine, and in checking various data points with information in service manual (Doc. No. 83147) I didn't notice any serious outliers. Auto tune wants to adjust gain to around 40-50%, at this gain setting there are no echoes whatsoever. Manually adjusting the gain to 80% will begin to yield some echoes, and at 90% (as in attached picture) there are strong yellow echoes right around unit and general blue clutter at a further radius. I understand that this environment is not a good test for judging radar performance.

My questions are (1) if the auto tune setting is what is to be expected in this case, and also (2) if it is normal to not see echoes in this type of environment until the gain is cranked up above 80%.

As always, thanks for the help.

Evan