The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] S2G to X30 Wiring Help

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] S2G to X30 Wiring Help
06-01-19, 08:11 AM (This post was last modified: 06-04-19 08:53 AM by Chuck - Raymarine - Moderator.)
Post: #1
Details GPF Offline
Junior Member
**
 		Posts: 1
Joined: Mar 2019
Reputation: 0
[CA11] S2G to X30 Wiring Help
Hello, I am new here and have a failed S2G. I have been told that the X30 is the best route for replacing. I purchased one used, but looking at the connections... There are some obvious differences.

Most of it looks very similar however I have a NEMA1 and NEMA 2 block on the S2G, and only NEMA block on the X30. I have a green and blue wire attached to the NEMA 1 Terminal (+/-) and three wires into the NEMA 2 (+) and another 3 wires into the NEMA 2 (-)...

I am left scratching my head, any help would be greatly appreciated.


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] S2G to X30 Wiring Help - Details GPF - 06-01-19 08:11 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication