Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Interfacing older spx-5 course computer to newly installed Seatalk by network
06-13-19, 03:27 PM (This post was last modified: 06-13-19 03:29 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] Interfacing older spx-5 course computer to newly installed Seatalk by network
Welcome to the Raymarine Forum E38-Valhalla,

It is indeed possible to interface a SPX autopilot to the devices which you have specified. It would be recommended that the MFD be operated with LightHouse II v19.03 software rather than LightHouse 3 software to permit use of the Autopilot Controls feature of LightHouse II if so desired. The LightHouse 3 Autopilot Controls feature is exclusively compatible with Evolution autopilots. The SPX autopilot course computer must also be updated with the latest available Raymarine product software update. The course computer's software may be updated though the SeaTalkng network via the MFD. The p70/p70R and the p70S/p70RS autopilot control heads which replaced them may be used with a SPX autopilot course computer which has been updated with the latest software.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Interfacing older spx-5 course computer to newly installed Seatalk by network - Chuck - Raymarine - Moderator - 06-13-19 03:27 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)