The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] red dots possibly depth how to change?

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] red dots possibly depth how to change?
06-28-19, 05:20 PM (This post was last modified: 07-03-19 11:53 AM by Chuck - Raymarine - Moderator.)
Post: #1
mystery Offline
Junior Member
**
 		Posts: 7
Joined: Nov 2017
Reputation: 0
[CA11] red dots possibly depth how to change?
I am trying to figure out what these red dots are on my charts. I am guessing related to depth. I tried changing my minimum draft to 1' and they still show in areas where there is 5-6 feet of water per the chart.

I read the manual and it said during the initial setup that maximum vessel draft, safety margin, and minimum safe depth are set but these can be changed from the settings after initial setup. I cannot find these three categories.

In the attachment I circled the depths...

Any thoughts?

Thanks!


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] red dots possibly depth how to change? - mystery - 06-28-19 05:20 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication