[DG11] ST1000 tiller pilot interface to i70s

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[DG] [DG11] ST1000 tiller pilot interface to i70s

08-02-19, 03:49 PM (This post was last modified: 08-05-19 09:15 AM by Chuck - Raymarine - Moderator.)

Post: #3

cmackg Offline

Junior Member

Posts: 3
Joined: May 2019
Reputation: 0

RE: [DG11] ST1000 tiller pilot interface to i70s

I have the same question, but I wonder could I instead make up a cable that connects the ST1000 to either the ITC-5, or a T-connector by the I70s? I have the I70s depth,speed wind bundle. And later, assuming I added a MFD screen, there'd be no other changes needed, right? It would all be on the network.

« Next Oldest | Next Newest »

Messages In This Thread

[DG11] ST1000 tiller pilot interface to i70s - colin - 07-22-19, 07:07 AM

RE: [DG11] ST1000 tiller pilot interface to i70s - Derek - Raymarine - Moderator - 07-24-19, 06:49 AM

RE: [DG11] ST1000 tiller pilot interface to i70s - cmackg - 08-02-19 03:49 PM

RE: [DG11] ST1000 tiller pilot interface to i70s - Louise - Raymarine - Moderator - 08-08-19, 02:39 AM

User(s) browsing this thread: 1 Guest(s)