Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] New EVO Autopilot work with RL80C?
07-29-19, 03:23 PM
Post: #2
RE: [CA11] New EVO Autopilot work with RL80C?
Welcome to the Raymarine Forum truk911,

While an Evolution autopilot may be used with a hsb/hsb2/SL Pathfinder Series Display, it would be recommended that it be interfaced to the display's NMEA 0183 output communications interface. An Actisense NGW-1-ISO NMEA 0183 to NMEA 2000 data bridging device would typically be recommended for this purpose. A NMEA 0183 Output Cable packaged with each Pathfinder Series Display. Should this cable not be located then 1/8" female blade connectors may be attached to the NGW-1-ISO's NMEA 0183 input leads to permit them to be mated to the 1/8" male blade connectors within the Pathfinder Series Display's NMEA 0183 Output socket. The NGW-1-ISO's DeviceNet (M) plug may be adapted (via an A06075 / 39.4in (1.0m) DeviceNet Female Cable) to be mated to spur socket within the powered and properly terminated SeaTalkng / NMEA 2000 backbone.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] New EVO Autopilot work with RL80C? - Chuck - Raymarine - Moderator - 07-29-19 03:23 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)