The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.3.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error

Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG11] Wheel Pilot error.
08-06-19, 09:28 AM (This post was last modified: 08-07-19 02:41 PM by Chuck - Raymarine - Moderator.)
Post: #1
[DG11] Wheel Pilot error.
My system has developed a problem whereby the readout on the wheel pilot differs from that on the ships compass, thereby rendering the Autohelm unusable.
The difference (bearing offset) resembles a deviation curve (see attached spreadsheet) from no difference to about twenty degrees out (+ve), back through no error and on to 20 degrees out (-ve).
I have tried, several times, to recalibrate the Wheel Pilot (Autohelm)
I have checked the ships compass against a hand held.
I have checked that there is nothing near the fluxgate compass that could influence it.
I have disconnected the fluxgate from the instrument and measured the resistance across the various pairs as described on the Raymarine fault finding notes and all are well within tolerance.
Its a Seatalk1 system ST4000+ and Fluxgate plus several other instruments.
Any help would be much appreciated.
Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
[DG11] Wheel Pilot error. - russ_stuart - 08-06-19 09:28 AM

Forum Jump:

User(s) browsing this thread: 1 Guest(s)