Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Seatalk and NMEA data crossover on S2 autopilot
08-07-19, 04:00 PM (This post was last modified: 08-07-19 04:06 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] Seatalk and NMEA data crossover on S2 autopilot
Welcome to the Raymarine Forum,

It would generally be recommended that an E22158 SeaTalk to SeaTalkng Converter Kit be installed for such purposes. Doing so would not only ensure that each device has access to data from the SeaTalk bus and SeaTalkng backbone, but doing so may also avoid potential creation of a NMEA 0183 data loop. The latter may be created when data received via a devices NMEA 0183 communications interface is re-transmitted (via its NMEA 0183 output port) back to the original transmitter. For this reason, those electing to interface via NMEA 0183 will do so in a manner which would support one way communications or will install a programmable NMEA 0183 multiplexer (ex. Actisense NDC-4-USB, etc.) to filter out re-transmitted NMEA 0183 sentences sent from the MFD to the autopilot. Please click here to view a FAQ addressing this subject.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Seatalk and NMEA data crossover on S2 autopilot - Chuck - Raymarine - Moderator - 08-07-19 04:00 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)