Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] Axiom units chane from ft/miles to m/km
09-10-19, 10:52 PM
Post: #8
RE: [TG11] Axiom units chane from ft/miles to m/km
Hello @Jorgen,

Depth units changing can have a different cause, it's not necessarily the same problem. Depth units can be changed to feet in systems where you have a mixture of Seatalk1 and SeatalkNG products where you have depth data being generated on one network and viewed on the other. This is because of the very old and limited design of the Seatalk1 network (which we cannot change because of the number of old devices out there which it must work with) and the default unit selection on ST1 of feet (that's how old Seatalk1 is.)

Do you have a mixed ST1 / STNG system?
Where in your system is the depth data coming from?
Do you have an ST1-STNG Convertor (part E22158) in your system?

Thanks,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [TG11] Axiom units chane from ft/miles to m/km - Tom - Raymarine - Moderator - 09-10-19 10:52 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)